Ribbed Closure Lotion Dispenser Pump 24/410 Custom Pantone Private Label Colors

A private label range lives or dies on its colour story. Four shampoo variants, four pumps, four shades that have to sit together on a shelf without one looking like a mistake. This 24/410 Ribbed Closure Lotion Dispenser Pump is set up for exactly that workflow: masterbatch dosing on a small machine allows a Pantone match from 5,000 pieces per colour, and the ribbed closure gives the cap a grip reference point that smooth wall pumps do not.

Because colour is dosed inside the moulding cell rather than painted on afterwards, the shade is integral to the part. There is no coating to chip at the rib edge, no solvent residue to declare, and the recycling stream stays mono material PP.

• Minimum order quantities of 30,000 per colour that make a six shade range impossible for a mid sized brand.
• Painted or sprayed collars that chip at the rib edge after a few weeks of handling.
• Shade drift between production runs that turns matching bottles into a mismatched pair.
• Long colour approval cycles that delay a seasonal launch past its window.

• Pantone From 5,000 pcs: Small machine masterbatch dosing makes short colour runs viable, so a six shade range can be ordered without sinking capital into dead stock.
• Integral Colour: Colour is moulded in rather than sprayed, so there is nothing to chip at the rib edge and no solvent declaration is needed.
• Ribbed Grip Finish: Fine rib and deep rib closures give a tactile grip that reads as a quality signal next to a smooth wall cap.
• dE Under 1.0 Control: Each run is checked against the approved chip on a spectrophotometer, so a repeat order does not arrive a shade lighter.
• Matching Cap Supply: Caps, discs and pumps can be produced in the same batch so the finished bottle is a single shade, not two near shades.
• Fast Colour Loop: A physical chip is couriered within five working days of artwork, compressing the approval cycle to about two weeks.

Used across private label hair care, body care and hotel amenity ranges where several SKUs share one bottle family but need individual colours. The 24/410 neck fits 250ml and 400ml PET and HDPE bottles, and the ribbed closure is the usual choice for brands whose cap tooling already carries a matching rib detail. Retail buyers reviewing a range on a shelf read consistent rib geometry and consistent shade as evidence that one supplier controls the whole pack, which is a small but real advantage in a competitive tender.

Six hundred pumps per carton at 52 x 38 x 41 cm, colour separated with a printed label on each carton so a warehouse picker cannot confuse two shades. Orders start at 10,000 pieces in total, with 5,000 minimum per colour. Stock shades ship in 15 working days, matched colours in 25 days from chip approval. Defective colour is treated as a full claim: if a delivered lot exceeds dE 1.0 against the approved chip, the lot is remade at our cost, because a shade failure in private label is a launch failure for the customer.